Wouter A. Serdijn

Chutham Sawigun

As the requirements for low power consumption and very small physical dimensions in portable, wearable and implantable medical devices are calling for integrated circuit design techniques using MOSFETs operating in the subthreshold regime, this book first revisits some well-known circuit techniques that use CMOS devices biased in subthreshold in order to establish nanopower integrated circuit designs. Based on the these findings, this book shows the development of a class-AB current-mode sample-and-hold circuit with an order of magnitude improvement in its figure of merit compared to other state-of-the-art designs. Also, the concepts and design procedures of 1) single-branch filters 2) follower-integrator-based lowpass filters and 3) modular transconductance reduction techniques for very low frequency filters are presented. Finally, to serve the requirement of a very large signal swing in an energy-based action potential detector, a nanopower class-AB current-mode analog multiplier is designed to handle input current amplitudes of more than 10 times the bias current of the multiplier circuit. The invented filter circuits have been fabricated in a standard 0.18 µ CMOS process in order to verify our circuit concepts and design procedures. Their experimental results are reported.

Analog IC Design Techniques for Nanopower Biomedical Signal Processing

Gianluca Setti

Aleksandar Tasic

The idea for this book originated from a Special Session on Circuits and Systems for Future Generations of Wireless Communications that was presented at the 2005 InternationalSymposiumon Circuits and Systems, which was then followed by two Special Issues bearing the same title that appeared in the March and April 2008 issues of the IEEE Transactions on Circuits and Systems – Part II: Express Briefs. Out of a large number of great contributions, we have selected those tting best the book format based on their quality. We would like to thank all the authors, the reviewers of the Transactions on Circuits and Systems – Part II, and the reviewers of the nal book material for their efforts in creating this manuscript. We also thank the Springer Editorial Staff for their support in putting together all the good work. We hope that this book will provide you, the reader, with new insights into Circuits and Systems for Future Generations of Wireless Communications.

Circuits and Systems for Future Generations of Wireless Communications

Marcel J. van der Horst

André C. Linnenbank

This book enables circuit designers to reduce the errors introduced by the fundamental limitations (noise, bandwith, and signal power) and electromagnetic interference (EMI) in negative-feedback amplifiers. The authors describe a systematic design approach for application specific negative-feedback amplifiers, with specified signal-to-error ratio (SER). This approach enables designers to calculate noise, bandwidth, EMI, and the required bias parameters of the transistors used in application specific amplifiers in order to meet the SER requirements.

Wouter A. Serdijn

Books

Your next favorite book is out there